Mouseover to zoom or click to enlarge

Reeves Custom Jimmy 50

Reeves Custom Jimmy

The Custom 'Jimmy' is a faithful recreation of Page's Hiwatt amp that he used circa 1969 - 1971.  Constructed to the exact same specifications as an original HIWATT® design with Partridge replica transformers, dual channel pre-amp with 4 Inputs (2 Normal, 2 Bright). Normal volume and bright volume, bass, middle, treble, presence and master volume controls. Like all Reeves Amplifiers, the Custom Jimmy is entirely hand assembled using only the finest quality components assembled on a Garolite turret board utilizing "Mil-Spec" wiring techniques. 

What makes this amp different than other Hiwatt circuits of the same period is that is has more gain on tap...more vintage Marshall in nature.  And something even more unique is its foot switch volume cut.  The amount of volume cut is adjusted by the balance control on the front other words, the amp can be played with a more aggressive preamp tone (adjusted by the input control) and then switched, via the foot switch, to a less aggressive-more typical cleaner Hiwatt tone .  It works kind of like a two channel amp, but it is not.


25-3/16”(width)x 10-7/8” (height)x 11-1/4”(depth)


    All-tube circuit

    Hand wired turret board construction

    50 watts via 2 EL34 output tubes (Custom 50)

    100 watts via 4 EL34 output tubes (Custom 100)

    3 12AX7 preamp tubes and 1 x 12AT7 phase inverter

    Transformers wound to original Partridge specifications

    Footswitchable volume cut (foot switch included)

    Switchable 4,8,16 ohm impedance switch on the rear of the unit

    100V, 120V, 230V, 50/60Hz voltage selector on the rear of the unit MADE in USA

Price: $2,299.00

Status: Sold


Copyright 2023 The Amp House. All Rights Reserved.

Web Design Tulsa | Sitemap