Reeves Custom 50PS
The Custom 50 PS is the same circuit as our
standard Custom 50 but with the addition of Power Scaling to give you that
"Live at Leeds" tone without disrupting the neighborhood.
to the exact same specifications as Dave Reeves original HIWATT™ design with
Partridge replica transformers, dual channel pre-amp with 4 Inputs (2 Normal, 2
Bright). Normal volume and bright volume, bass, middle, treble, presence and
master volume controls. Like all Reeves Amplifiers, the Custom 50 is entirely
hand assembled using only the finest quality components-resistors and
capacitors assembled on a Garolite turret board utilizing "Mil-Spec"
Following closely to the original design the Reeves Custom
50 is the new leader in high headroom-low distortion amplification. If you are
looking for an amplifier as solid base for laying your pedals on top of - then
the Custom 50 will provide dynamic impact, soundstage focus and detail.
25-3/16" (width) x 10-7/8 " (height) x
11-1/4 " (depth)
Hand wired turret board construction
50 watts via 2 EL34 output tubes (Custom 50)
3 12AX7 preamp tubes and 1 12AT7 phase inverter
Transformers wound to original Partridge
Switchable 4, 8, and 16 ohm impedance switch
100V, 120V, 230V, 50/60Hz voltage selector